Contact Us
Tel: +86-510-81818636
Fax: +86-510-81818633
E-mail: mould@sfxsteel.com
Address:
Location: HomeProductsPM 53(ASP53)
PM 53(ASP53)
Chemical composition
| C | Cr | Mo | W | V |
| 2.48 | 4.2 | 3.1 | 4.2 | 8.0 |
Typical applications
| Cold work tool | Knife Board | Paper cutting or sawing tools |
| Europe | HS 4-3-8 |
Delivery hardness
| Max 300HB |
PM53 is a kind of high wear-resistant and cold ultra-pure powder metallurgical tool steel containing high vanadium, it can be applied in stamping, powder compacting, industrial paper and wood cutting. It is recommended to take the way of PVD/CVD coating, the maximum of nitride layer thickness is controlled range from 2 to 15 ¦Ìm.
| Supply size |
|
| Forging materials | Size range£¨mm£© |
| Round | 90-380 |
| Party/partial | Maximum width 450 |
|
|
Minimum thickness 40 |
| Rolled products |
|
| Skinning | 10-72 |
| The black board eraser | Thickness 5-55 |
|
|
Width 20-260 |
|
Special shapes |
As required |
|
PM module |
400*500*2100 |
|
|
400*500*1100 |
|
|
400*500*1000 |
|
|
400*250*1000 |
|
|
500*200*1000 |
Annealing treatment
Cooling to 700¡æ slowly at a rate of 10¡æ/h under protective atmosphere of 850-900¡æ,then air cooling.
Strain relief
Keeping in 600-700¡æ for 2 hours, and cooling to 500¡æ slowly.
Quenching
Preheating in two steps under protective atmosphere, 400-500¡æ and 850-900¡æ, and choosing the right temperature depending on the hardness and then cooling of austenite to 40-50¡æ.
Tempering
560¡æ 3 times, each time for at least 1 hour, cooling to room temperature after each tempered.